|
JNX500 DVD Box Packup Machine
|
Thanks choose our products. To ensure
a smooth operation and good understanding our machine.
Please read this manual before installation and keep it
as a reference in the future. |
A:Introduction:
the DVD box Packup
Machine JNX500 is working together with the JNX200A DVD Auto welding
machine.  This
machine can packup the dvd cases into pcs/pack after the welding
machine weld the sleeves automatically. pack qty can be DIY upto 50
PCs.
the JNX500 is
controlled by PLC,Working Stably.all control port at I/O page,can
easily discover the problem. The Conveyer Belt Electronic machine
speed is adjustable. Can work smoothly with the welding machine
welding speed.
the Packup machine
work with 220V and 50HZ need the air pressure @ 0.6Mpa.
B:the cylinder
working process is:
Box Pushing
cylinder--UP Propup Cylinder--Holder Cylinder--Down Propup
Cylinder--Holder Cylinder--Protector Cylinder--Box Outing Cylinder.
all cylinder
working situation is position control. to ensure the last working
position is correct then will start the following process.anything
not normal or any problem like not in position,,the machine will
stop.
C:Machine
installation.
Install the
machine into the welding machine box recieving body.(see the pic ).remove
the small box of the welding machine, install the box packup machine
in the place where we had installed the small body of the welding
machine.make the packer horizontal then conect the packer and the
welding machine use 4 screw (6*100).
D:how to use.
1:add
the 200V and 50 HZ Single phase electronics and also the air
pressure 0.6Mpa and then start the machine. unpress the emurgency
botton then can start the machine.touch the (auto) botton in the
control penal, then the machine start working automatically. if the
box storage don't have box feeding.the conveyer belt will working
but the cylinders will not working. once add the cases, then the
cylinders start working.
2:different
thickness packing.
JNX500 Packup
machine can use to packup the dvd box from 5mm to 15mm. to change
the pack up thickness just change the right board will be ok. the
standard spare board is 7mm dvd case,9mm dvd case and 14mm dvd case .
if have others, pls make a special order from us.
E:lubrication
the Cylinder and
Magnetic Valve Lubrcate controlled by the oil mister.the valum for
spending the oil is controlled by the screw from the oil
mister.normally set from 0-1.the oil is using 32# Turping oil. have
to ensure the oil tank have oil.
the lubrication
for the bearings, need 1 time each time before using the machine
.cannot too much. just have oil in the surface of the bearings will
be fine. | 
